It is very necessary for the initial installation, commissioning and operation of hf welded steel pipe mill line equipment, because we can only be as perfect as possible, but perfection does not exist, and unexpected situations will inevitably occur, which requires debugging and solve.

　　The following problems should be paid attention to when the hf welded steel pipe mill line equipment is initially installed and debugged on site. The first is the frequency debugging of the high-frequency welding machine, because the power of the high-frequency welding machine is often the same. The frequency is not the same, this should be carefully debugged on site.

　　In fact, it is the debugging of the running direction and the electronic control system. There are many cables in the hf welded steel pipe mill line equipment. If any one of the wires is connected incorrectly or reversely, the running direction may be wrong. This is to be confirmed by debugging.

　　In addition, after the equipment installation and electronic control debugging of the hf welded steel pipe mill line, it is necessary to install the mold for trial production, so as to check whether the mold design is suitable, and whether the performance of the high-frequency welded pipe unit equipment meets the design requirements, these are debugged and checked. , and once qualified, it can be formally handed over to the customer.

　　There are not many problems with hf welded steel pipe mill line equipment, but to do these work, it is necessary to ensure that no accident occurs. Even if an accident occurs, it can be dealt with in time, so that customers can feel that our product quality and service quality are better. of.