As the main grinding equipment, the direct forming tube mill directly affects the economic benefits of the enterprise. How to dig and increase the output per hour is a problem that we are very concerned about. Now, according to the author's cognitive level, I will briefly discuss the measures to improve the mill hour. 

　　The direct forming tube mill first starts with the feeding of the mill, whether it is screw feeding or cone feeding, if the incoming speed is too fast, it will directly rush into the inside of the mill, so that the front end of the mill will not produce powder because there is no material. grinding action.

　　Therefore, when such a situation is found, if the front end material is less or the large particles are less after stopping the grinding, the blanking height difference of the slide should be appropriately reduced or the feeding speed should be reduced in a roundabout way; if the blanking height difference is not easy to change, it can be Add a feeder to reduce the feeding speed. However, the direct forming tube mill manufacturer believes that no matter how it is changed, it must be based on the purpose of reducing the feeding speed so that all grinding bodies can function, which is equivalent to increasing the length of the mill and expanding the effective volume of the mill.

　　Second, the effective diameter of the direct forming tube mill can be appropriately expanded. In order to increase the reliability of the lining plate, some units do not hesitate to increase the thickness of the lining plate, which is actually reducing the effective diameter of the mill and the effective volume of the mill, which is very unfavorable for the output of the mill. Appropriately improve the quality grade of the lining plate, minimize the thickness of the lining plate, and expand the effective volume of the mill.

　　Usually we can see that the output of the direct forming tube mill extends over time, and the stage is gradually increased. This is the reason. Of course, this is the effect without changing the function of the lining plate. If the lining plate is worn to the point that the function disappears, another Not to mention, such as graded liner grinding and so on.

　　Therefore, the replacement of the lining plate of the direct forming tube mill should be comprehensively evaluated. If it can be used safely, it should be extended as much as possible, and the thickness of the lining plate should be reduced as much as possible. Of course, this must be carried out on the premise of ensuring the safety of the mill.